![]() ![]() Place tube (M or N) into Anti-Vibration Tailpipe Mount™. Push wires into disposer (do not displace cardboard shield) and replace electrical cover plate. Unit must be grounded for safe and proper installation Connect white wire from disposer to neutral (white) wire from power source and black wire from disposer to hot (black, red) wire from power source with wire nuts (not included) ground wire to green grounding screw. WARNING! Improper grounding can result in electric shock hazard. This disposer requires a switch (15 amp minimum rating) with a marked “Off” position (wired to disconnect all ungrounded supply conductors) installed within sight of the disposer sink opening, except if using an air switch or batch feed accessory, or batch feed disposer. ![]() Insert cable connector (not included) and run electrical cable through access hole on bottom of disposer. Turn disposer over and remove electrical cover plate. Knock out drain plug and remove plug from inside of disposer. ![]() Turn disposer (J) onto side and insert screwdriver into dishwasher inlet. If you do not need to attach the dishwasher, go to Step 16. Use shorter 1-1/8” screws (H) if sink is more than 3/8” thick. Tighten 1-1/2” screws (G) evenly and firmly against backup flange. ![]() Pull snap ring (I) open and press firmly until it snaps into place. Place a weight such as the disposer on the sink flange to hold it in place. Hold flange (C) in place while inserting snap ring (I). Insert fiber gasket (D), backup flange (E) and mounting ring (F).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |